Mechanical failure of spindle end


The spindle end was jammed on the assembly fixture, and a large deformation and burr appeared in the rim. The spindle was stuck and could not rotate. Each axis could move. No alarm.


After careful observation, found that the end shield were dislocated due to the fact that the shield was jammed by the assembly and was stuck on the bearing end cover, and could not rotate along the axis. Dislocation to a certain extent, the axis would no longer be able to rotate and stopped.
With a plate slightly sharpened, struck the shield along the rim with moderate force and took it down. Now the spindle could turn. Repaired the shield.

4 comments on “Mechanical failure of spindle end

  1. Hey there! This post could not be written any better!
    Reading this post reminds me of my old room mate!

    He always kept chatting about this. I will forward this article to him.
    Pretty sure he will have a good read. Thank you for sharing!

Leave a Reply

Your email address will not be published. Required fields are marked *